One of the most common issues with Saniflo products is a misfiring microswitch. How to Unblock a Saniflo Toilet – The Microswitch If your unit is still under warranty and you are concerned about undertaking this procedure yourself, please get in touch with one of the Saniflo experts at Blockbusters. Please note that disassembling your Saniflo system will void your warranty. Make sure to wait until the toilet tank refills with water before attempting to flush. Reassemble the Saniflo unit and pipes, turn the water flow back on and return power to the Saniflo system. From here, there should be no other blockages.If there are blockages located in the hole in the Saniflo unit where waste enters the macerator, flush it with warm water.If there are any blockages in the connector located at the back of the toilet, flush it with warm water.If any remaining water spills out, mop it up as needed. Pull the Saniflo free from the back of the toilet.Unscrew the screws at the base of the Saniflo system and pinch the two ends of the metal clip on the connector between the Saniflo and the toilet to loosen it.After draining completely, remove the pipes and clear any blockages that have formed inside using warm water or a plumbing snake.Use a wrench to loosen the pipes and allow any residual water to flow into the bucket.Place a bucket underneath the pipe running from the top of the Saniflo system.Remove as much water from the toilet as possible.To stop the water flow, turn the lever near the back of the toilet tank.Disconnect the power supply to the Saniflo.Make sure you’re wearing protective rubber gloves and a mask while also protecting any other parts of your body in order to prevent contact with solid human waste. Here’s the best way of unblocking a Saniflo toilet. Items like period pads, too much toilet paper, and foodstuffs can clog the pipe, and cause the toilet to block completely. Just like any other toilet, Saniflo toilets can become blocked if inappropriate items are flushed into them. This guide explains how to unblock a Saniflo system, as well as solutions to some other common problems that may arise in your time using your Saniflo. So, what is the best way to unblock a Saniflo toilet? You’ll need to take the system apart to manually clean it in order to prevent any damage from occurring to the system. If you attempt to use a plunger to unblock a macerator, it could mean that you damage the macerator which will require the Saniflo to be prepared by a specialist. The intuitive design of the Saniflo means that the built-in macerator grinds up solid waste into smaller particles that flow through your waste pipes with ease.īecause of the complicated design of the Saniflo, if you develop a blockage or clog within the system, you cannot simply use a plunger to remedy the issue at hand. Saniflo systems enable you to install a toilet in almost any room of a building where there is access to a waste disposal pipe. How to Unblock a Saniflo Toilet and Other Common Problems Explained
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |